Installing Adapter Brackets to Screen
NOTE: If screen has a VESA 400 horizontal mount-
ing pattern, skip to step 2-3 or 2-4 on page 9.
NOTE: For dedicated PLP plate installation skip to
step 4 on page 12.
Remove four 1/4-20 x .6" screws using 5 mm allen
2
wrench (I) and loosen two 1/4-20 x 1.25" screws
1/2 turn to allow for screen bracket adjustment.
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen.
2-1
Place screen face side down and refer to screen manufacturers instructions for removing obstructions from the
back of the screen. Adjust screen brackets to align with screen mounting holes.
Measure horizontal mounting hole pattern and choose fi xed stop-position from chart below. NOTE: If horizontal
mounting hole pattern on back of display has a VESA 200 pattern, skip to step 3 on page 10.
horizontal mounting hole pattern
10-3/4" - 16-1/16" (273 - 408 mm)
15-1/16" - 21-9/16" (383 - 548 mm)
20-7/16" - 27-9/16" (519 - 700 mm)
fixed stop-position
#1
#2
#3
FIXED STOP-POSTION #1
7 of 58
1/4-20 x .6" SCREWS
FIXED STOP-POSTION #3
FIXED STOP-POSTION #2
ISSUED: 10-30-09 SHEET #: 095-9297-4 10-01-10
1/4-20 x 1.25" SCREWS