PEERLESS SA752PU Instalación Y Montaje página 9

For Flat Back Screen
Begin with the shortest length screw, hand thread
2-3
screw through multi-washer and screen brackets
(B) into screen as shown below. Screw must make
at least three full turns into the mounting hole and
fi t snug into place. Do not over tighten. If screw
cannot make three full turns into the screen, select
a longer length screw from the baffl ed fastener
pack. Repeat for remaining mounting holes, level
screen brackets and tighten screws.
NOTE: Spacers may not be used, depending upon
the type of screen.
Skip to step 2-5.
For Bump-out or Recessed Back Screen
Begin with the longest length screw, hand thread
2-4
screw through multi-washer, screen brackets (B)
and spacer in that order into screen as shown
below. Screw must make at least three full turns
into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three
full turns into the screen, select a shorter length
screw from the baffl ed fastener pack. Repeat for
remaining mounting holes, level screen brackets
and tighten screws.
Center screen brackets horizontally and vertically
2-5
on back of screen. Tighten two 1/4-20 x 1.25"
screws. Reinstall four 1/4-20 x .6" screws using
5 mm allen wrench (I) into appropriate fi xed-stop
position from chart on page 7.
SCREEN
B
SCREEN
B
1/4-20 x 1.25" SCREWS
9 of 58
ISSUED: 10-30-09 SHEET #: 095-9297-4 10-01-10
MULTI-WASHER
MULTI-WASHER
SPACER
1/4-20 x .6" SCREWS
SCREW
SCREW