Gas Cylinder - Char-Griller 5030 Manual Del Usuario

Lighting Burner with a
Match
1. Push in and rotate knob to HIGH position
2. Place match in match holder installed on side of grill
housing. Once lit, place fl ame through cooking grates
near burner ports, as shown. Burner should light
immediately.
3. Adjust knobs to desired cooking settings.
Observe Flame Height When
Lit
View burner fl ame through fl ame viewing hole. Flame
should be blue and yellow in color, and approximately
1/2-inch to 3/4-inch tall on HIGH setting.
Disconnecting the Gas
Cylinder
1. Turn all control knobs to the OFF position and turn the handle on the
gas cylinder clockwise until it stops.
2. Turn coupling nut on regulator in a counter-clockwise direction until
regulator is released from threaded gas cylinder valve nozzle.
3. Place dust cap on cylinder valve outlet whenever the cylinder is not
in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage of propane.
Storage of Appliance
Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from
the appliance. When the appliance is not in use, it should be covered and stored in a dry, dust-free
environment.

Gas Cylinder

The gas cylinder should not be dropped or handled roughly! If the appliance is not in use, the gas must
be turned off at the supply cylinder. Replace the protective cap on the cylinder after disconnecting the
cylinder from the appliance.
C-4