Time Search - Swann DVR4-5000 Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

System Menu (cont)
Event List: Displays a list of recorded events from the most recent recording to
the oldest. Use the Time Search feature for older events not in list.
Keypad Tone: Turns the "beep" when a button is pressed on or off.
Date & Time
Recording
Number
Loss Alarm: When enabled an audible alarm will sound indicating the DVR has
lost the camera signal or a camera has been unplugged.
PTZ Setup: Here you can configure a PTZ (Pan, Tilt, Zoom) camera system.
F/W Upgrade: Displays the current firmware version and allows future upgrades
via a USB Flash Drive. Do not remove the Flash Drive while the firmware is updat-
ing as it may damage the DVR. Only use updates authorized by Swann. When
complete, remove the Flash Drive and restart the DVR.

Time Search

Start time: This is the date and time of the oldest recording on the DVR.
Stop time: This is the date and time of the final recording on the DVR.
Use the CH1 & Ch2 buttons or the mouse to select each digit in the time/date.
Change the value of each digit by using CH3 & Ch4, or clicking the red arrow
with the mouse.
Enter a time between the Start and End time and press the Play button to view
a recording. Use the Fast Forward and Rewind buttons to quickly scan through
recordings, press multiple times to speed up playback dramatically.
Press the Stop button to exit playback mode.
Start / Stop
Use the arrow buttons to select and
Event
playback the highlighted Event. Press
Recording
Type
Stop to exit playback mode.
Hint: You can also access the Event List
by pressing the Play button while view-
ing your cameras.
Time Search allows you to quickly jump
to a specific time and date to view a
recording.
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido