marklin 76471 Manual De Instrucciones página 10

Signal Installation
The following work steps may be done only when there is no
voltage present:
Switch 10 off = fx (MM) / mfx
Switch 10 on = DCC
table starting on Page 18)
Please note: Always do settings with the DIP switches when
Programming with the CS 2
fx (MM)
Only one signal may be connected to the programming track at
a time
During programming with the Central Station, by contrast the
An fx dummy locomotive with the address of the signal must be
10
1-2,040 DCC
The procedure for programming with the 6021 Control Unit can
Please see the operating instructions for the control devices in
DCC
one signal may be connected to the programming track at a
time
The signal will blink for monitoring purposes during the data
Please see the operating instructions for the control devices in
CV for fx (MM) and DCC
CV Meaning
1 Address 1 - 255
9 Addresses 256 - 2040
33 Numer of output
addresses
Only
Values
1-255 (1) only DCC
0-7 (0) only DCC
read only DCC
-