Complete Shutdown Procedure; Equipment Maintenance - Astralpool 33556 Manual De Instalación Y De Mantenimiento

7.2 Complete shutdown procedure

In the event of an extended shutdown of the pool treatment equipment (due to vacation, maintenance, repair, etc.),
perform the following steps:
1. Stop the Ozone Generator ozone equipment by releasing the pushbutton(s). The pushbutton indicators will turn off.
2. Stop the pressure pump (depending on model).
Ozone Genetarors Ozone Generator
Triox Spas/Triox R-1 Triox R-2
70/5 (07946)
3. Close the PVC inlet valve for ozonated air to the venturi.
4. Close the ball valves of the general bypass.
IMPORTANT NOTE:
Never work on the Ozone Generator when it is connected.
Call the nearest technical service in the event of any problem.
When the equipment is running, air must be circulating inside the ozone reactor at all times.

8. EQUIPMENT MAINTENANCE

Check that the PVC bypass ball valve and the PVC ball valve of the inlet for ozonated air to the venturi are working
properly.
Inspect the venturi:
Air suction in the PVC glass tube
Clear, impurity-free ½" check valve (particularly the PVDF ball and stainless steel spring)
Make sure that there is no ozonated air leak in the equipment, sealing it if necessary. The Teflon tube must be properly
secured to the respective fitting.
Check that no water returns after the venturi and the safety kit, particularly in the water trap (see Figure 12). If
otherwise, drain the equipment. In addition, check that the check valve safety kit is working properly: The minimum water
level is marked in the cup; check the check valve of the venturi
Check the circulation pump (depending on the model), as indicated in the instruction manual for the pump.
Ozone Genetaror-1
Ozone Generator-2
70/5 (07946)
Ozone Generator
Triox R-3
Ozone Generator
Triox R-4
120/7 (07948)
70/7 (07947)
Ozone Generator-3
Ozone Generator-4
120/7 (07948)
70/7 (07947)
15 Ref.: Ozone generator-AstralPool-gb-R11