Astralpool 33556 Manual De Instalación Y De Mantenimiento página 37

•
The pushbutton indicator does not turn on when the pushbutton is set.
•
The filter pump or pressure pump are not in the run position.
•
The indicator bulb is blown.
•
There is no ozone generation.
•
The equipment is not running.
•
One or both of the pushbuttons are not set.
•
The transformer coils (1l) (Fig. 8A, 8B, 9A, 9B) do not work.
•
One or more electrical components of the 3A POWER board (3L) or the 3B POWER board (3l) (Fig.
7A, 7B, 7C, 7D) is broken.
•
The dielectric-electrode assembly (Fig. 8A, 8B) of the ozone reactor (2l) is damaged.
•
The pressure pump does not work.
•
No power is being supplied to the pump.
•
The thermal relay trips due to an overload caused by a short circuit or similar fault.
•
The thermal protector has tripped due to an overload.
•
There is no air suction in the Ozone Generator equipment.
•
The pressure pump is not working.
•
There is insufficient pressure at the venturi inlet.
•
There is no water in the check valve safety kit (water trap).
•
The inlet valve for ozonated air to the venturi is closed.
•
The check valve of the venturi is clogged.
•
The pneumatic equipment is not airtight.
18 Ref.: Ozone generator-AstralPool-gb-R11