Cleaning With Detergents; Shutdown - Mi-T-M CM Serie Instrucciones De Operación

OPERATING INSTRUCTIONS

CLEANING WITH DETERGENTS:

1. Refer to "Detergent Cleaning Precautions" pg. 6. Be certain to wear
protective safety attire as stated on pg. 10.
2. Prepare detergent solution according to label directions. Never pump
acids, akalines abrasive fluids or solvents thru the unit.
3. Attach clear plastic detergent hose to detergent hose barb on pump, if
not already attached.
4. Immerse the strainer into the detergent solution to allow detergent to
siphon.
5. Be certain the water supply is completely turned on.
6. With the trigger gun locked in the "OFF" position, connect the black 65°
detergent nozzle to the lance.
NOTE: This injection system is designed to apply
detergents under low pressure only. It will not allow detergent
solutions to be introduced into the system unless the black
detergent nozzle is used.
7. To apply solution, unlock the trigger gun and squeeze the trigger. In a
few moments a detergent/water mixture will exit the low pressure nozzle.
Start spraying the lower portion of the surface being cleaned and move up,
using long overlapping strokes. Applying from the bottom up helps avoid
streaking. Allow to soak briefly. (Avoid working on hot surfaces or in direct
sunlight to minimize the chances of the detergent drying, which may result in
damaging painted surfaces.) Be certain to rinse a small section at a time.
8. To rinse; lock the trigger gun in the "OFF" position, replace the black
detergent nozzle with the yellow 15° or green 25° nozzle. Unlock the trigger
gun and spray. It will take about 30 seconds to purge all detergent from the
line. For best rinsing results, start at the top and work down.
9. Siphon a gallon of water through the low pressure detergent injection
system after each use. This prevents the possibility of corrosion or detergent
residue causing mechanical problems during the next use.

SHUTDOWN:

1. Turn engine "OFF" as directed in the Engine Manual.
2. Turn the water supply "OFF".
3. Pointing the gun in a safe direction, trigger gun momentarily to relieve
any trapped pressure.
4. Once pressure is relieved, disconnect the nozzle assembly.
5. Drain gun, wand and hoses. Once drained, disconnect hoses.
6. Wipe unit clean and store with gun, wand and hoses in a safe area.
CM-Direct Driven Operator's Manual 2009 15