Clean Specific Materials; Clean The Stainless Steel - Arneg Barcellona Serie Guía De Instalación Y Manejo

Barcellona
English
6 carefully dry using a soft cloth
Should you notice ice built up, call a specialized technician.

20. 5 Clean specific materials

Material
• use a soft cloth with a neutral
detergent or soap and lukewarm
water (max 30°C).
• Immediately remove all traces of
water and detergent with a dry
Glass
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
• use a cloth soaked in neutral de-
Plastic
tergent
(door seal
• clean with a cloth soaked in clean
profiles)
water
Aluminium • Use a soft cloth with a neutral
detergent or soap and lukewarm
water (max 30°C).
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
• Use a soft cloth with a neutral
Wood
detergent or soap and lukewarm
water (max 30°C).
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
• If necessary, before treating the
entire surface, test on a small
hidden area and verify that the
cleaner will not damage the finish
or colour

20. 6 Clean the stainless steel

Certain situations can cause the formation of rust on the surfaces in steel, such as:
iron remains left on damp surfaces, limestone, chlorine or ammonia based detergents not rinsed
properly, food incrustations or residues, salt-saline solutions, dry residues of evaporated liquids.
Remedy recent stains and rust:
clean with shampoo or neutral detergents, using a sponge or a rag.
When finished, eliminate any detergent residue, rinse and thoroughly dry the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
42
Remedy
This intervention may however cause scratches to the surfaces due to the abra-
sive cleaning method. DO NOT use hydrochloric acid on stainless steel surfaces
What to avoid
DO NOT use hot water on cold glass surfaces;
the glass could crack and injure the operator.
DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
DO NOT use dirty cloths
gently place them on a flat surface, DO NOT
break or damage them
DO NOT use waxes, concentrated detergents,
which contain oil, bleach, glass cleaners, abra-
sive detergents or flammable fluids
DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
05060169 00 04-08-2017