GYS PLASMA CUTTER 85A Manual Del Usuario página 28

Speed
Torch-part gap
CHANGING THE GROOVE'S SHAPE
Width
Depth
Solutions
CONSUMABLES INSPECTION (ASSEMBLY AND DISASSEMBLY, SEE P.24)
Parts
Visually check the shield's internal hole.
Check for fragments that may have accumulated in
the shield.
Shield
Check the for damage and surface wear.
Shroud
Visually check the tailpipe's internal hole.
Tailpipe
Check for damage and wear on the surface and inside
the diffuser.
Check that the fumes' exhausts are not obstructed.
Diffuser
Visually check the electrode's internal hole.
Electrode
ERROR ICONS
Error codes appear whenever a problem is detected. These are classified by 2 digits codes
(Error type + error code) referring to the table below.
Only the error code with the highest priority appears on the screen.
Communication
Informs the user that an error has occured in the internal bus.
Warning
The machine keeps functioning. The user must interact with the machine to rectify the fault.
Thermal
The heat sink's temperature is outside the acceptable operating range.
28
PLASMA CUTTER 85A / 125A
Angle
Increase the
Accelerate Reduce the
the speed speed
Actions
GROOVE SHAPE
You may alter the groove's shape by changing the torch's speed, the distance or the
torch's angle.
Decrease the
torch-part torch part
gap gap
OK NOK
OK NOK
OK
NOK
NOK
OK
Raise the Reduce the Increase the
angle angle
Solutions
Replace the shield if the hole is not round anymore.
Eliminate all superfluous materials.
Replace the shroud when it looks damaged (traces of
burns).
Replace the tailpipe if the inner diameter is enlarged
or distorted.
Replace the diffuser if the surface is damaged or
worn, or if fume exhausts are obstructed.
Replace electrode when the insert is used (removal of
1.5 mm).
EN
Decrease the
current current