Air Filter; Fuel Filter; Spark Plug - Shindaiwa HT231 Manual Del Propietario - Operador

Air Filter

Remove the air filter element, and wash the element in clean, neutral sol-
1.
vent or warm soapy water. Rinse the element thoroughly, and then squeeze
dry before reassembly.
CAUTION!
Never operate the unit if the air filter assembly is damaged or missing or if the
air filter element is soaked with water!

Fuel Filter

■
Use a wire hook to extract the fuel filter from inside the fuel tank. Inspect
the fuel filter element. If it shows signs of contamination from debris,
replace it with a genuine Shindaiwa replacement fuel filter element.
Before reinstalling the filter, inspect the fuel line. If you discover damage
or deterioration, the unit should be removed from service unitl it can be
inspected by a Swisher-trained service technician.
CAUTION!
Make sure you do not pierce the fuel line with the end of the hooked
wire. The line is delicate and can be damaged easily.

Spark Plug

Keep the spark plug and wire connections tight and clean.
Adjust the spark plug electrode gap to .026 inch (.65 mm). If the spark plug
must be replaced, use only the spark plug recommended on the Specifica-
tions section or an equivalent resistor type spark plug of the correct heat
range.
CAUTION!
Before removing the spark plug, clean the area around the plug to prevent
dirt and debris from getting into the engine's internal parts.
14
Air filter cover
Hooked
Fuel filter
0.65 mm
(0.026 in.)
Remove the spark plug and adjust the
gap at the electrode
Air filter element
wire
spark plug gap--all mo