Bluetooth ® Operation - Tivoli Audio PAL BT Manual Del Propietário

Bluetooth Operation:
®
Prior to pairing, verify your device supports Bluetooth 2.1+EDR A2DP and your device is
not connected to any other Bluetooth product. Devices may pair differently. Below is a
general guide.
1. Turn the PAL BT to the "BT" position. This will power on the Bluetooth. Turn the volume
up about ¼ to start. Also turn up the volume on the source device (the device you are
streaming from).
2. Turn on the Bluetooth wireless technology on your enabled device.
3. Select "Tivoli Bluetooth (Not Paired)" when it appears on your device's screen to initiate
searching. Some devices may prompt you for a PIN. If so, enter "0000". "Tivoli Blue-
tooth" will change from "Not Paired" to "Connected".
4. You will hear a ring tone from the PAL BT confirming connection and you can begin
playing your music files wirelessly. Adjust the volume level on your device. You should
not have to pair your device again. Depending on your device, you may need to make
multiple attempts at Pairing and/or Connecting to the PAL BT, but please give
your device adequate time to Pair or Connect before repeating the process.
Pairing a Bluetooth
1. Turn the PAL BT to the "BT" position. This will power on the Bluetooth. Turn the volume
up about ¼ to start. Also turn up the volume on the source device (the device you are
streaming from).
2. Select "Settings".
3. Select "General".
4. Select "Bluetooth".
5. Switch Bluetooth "On" to initiate searching.
6. Select "Tivoli Bluetooth (Not Paired)" when it appears on the display. If you are
prompted to enter a PIN, enter "0000". "Tivoli Bluetooth" will change from "Not Paired"
to "Connected".
7. You will hear a ring tone from the PAL BT and you can begin playing your music files
wirelessly. Adjust the volume level on your device. You should not have to pair your
iPhone/iPod/iPad again.
The volume output level of music files varies. If you prefer an even higher output level,
check the settings in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off,
and the Volume limit Off.
If you encounter a problem Pairing, press the small arrow to the right of "Tivoli Bluetooth"
on your iPhone/iPod touch/iPad display and select "Forget this Device", then repeat the
Pairing process. Depending on your device, you may need to make multiple attempts
at Pairing and/or Connecting to the PAL BT, but please give your device adequate
time to Pair or Connect before repeating the process.
When streaming music, you can press the blue arrow to the right of the next track button >>/ on
the iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and Bluetooth.
• The PAL BT will remember pairing information for up to 8 devices. Additional devices can
be paired, but the least-recently used device will be replaced by the newly paired device.
• If the audio drops out or stops during playback, move your device closer to the PAL
BT, or check to be sure another wireless device is not interfering with the signal.
• When switching from Bluetooth to AM or FM, you may need to re-adjust the PAL BT's
volume level.
wireless technology enabled iPhone/iPod touch/iPad:
®
9 – ENGLISH