Emerson Easyheat Warm Tiles FGS Instrucciones De Operación E Instalación página 2

lcD Display
event/Program
Settings
GFcI Reset
Back/cancel
On/Off
InSTallaTIOn
New Construction Rough-In
• F asten electrical connection box (ECB) as required
per local electrical code on side of stud.
• D rill one 1-inch hole in base plate for single-cable
installation and two 1-inch holes for two-cable
installation.
• Thread pull-cord (not provided) through hole(s)
in base plate and in corresponding holes in ECB.
Secure the pull cords in the ECB.
Tie floor ends of pull-cord and fasten to floor.
• Install the guard plate (not provided) over the
hole for the cold leads and sensor wire before
drywalling.
• Install guard plate as shown in Figure 1.
Thermostat Installation
• Ensure the supply branch circuit has been
disconnected / de-energized.
• Pull sensor wire into ECB and secure to the floor.
See Figure 2. The sensor must not cross or overlap
any other cable on the floor AND must be
embedded in the cementituous based mortar in
the same manner as the heating cables.
• The floor temperature sensor wire can be
extended to a maximum of 50 feet with UL or CSA
recognized wire 22 AWG rated for 300 V.
• Prepare the thermostat for installation:
1. Remove the thermostat and screws from
packaging.
2. Loosen the screw on the bottom of the Front Panel
and lift the Front Panel as shown in Figure 3.
3. T rim excess length of supply branch circuit,
cold lead and temperature sensor cables, as
necessary, leaving about 6" projecting from
the ECB, see Figure 4. Most heating cables are
provided with identification labels attached to the
end of the cold leads – ensure that these labels
remain on the cold lead inside the ECB.
GFcI Test
next/Save
a. Button explanation
Up
Down
Hold
4. P repare each heating cable/cold lead for
connection/splicing and connection per Figure 5
or Figure 6, as applicable.
5. P repare the sensor wire per Figure 5 or Figure 6, as
applicable. Use screwdriver for connection to the
sensor wire connections (black and white wires) to
corresponding BLK and WHT terminals.
6. N eatly fold all wiring into ECB and fasten
thermostat with #6-32 screws provided. Do not
apply excessive force to the thermostat. Apply
firm but continuous force until the screws can be
fully seated.
7. Align the thermostat power base, then finish
tightening the two screws.
8. H ook the Front Panel unit to the top of the Power
Base unit, swing down and press the Front Panel
into the Power Base unit slightly, tighten the screw
at the bottom of the unit.
A. Button Explanation
lcD Display – Large scale readout with blue color
backlight which indicates the operational status of
the thermostat.
On/Off Button – Allows easy selection switching On
or Off the thermostat.
event/Program Button – Pressing this button once
enters the thermostat into programming mode or
cycles through the program events in programming
mode.
next/Save Button – Pressing this button accepts the
modified setting and cycles the program to the next
parameter.
-Pressing and holding this button down for 2 seconds
saves all changes that have been accepted during
the current programming cycles and exits the
programming mode.
Back/cancel Button – Pressing this button moves
the programming back to the previous setting
parameter.
2
Guardplate
Figure 1