Maintenance - GreenWorks MO09B01 Manual Del Propietário

MAINTENANCE

REPLACING T HE CUTTING BLADE (See Figure 9-10)
W A R N I N G
Always protect your hands by wearing heavy gloves and/or wrapping the cutting edges with rags
or other materials when performing any maintenance on the blades.
Use only a GREENWORKS replacement blade.
• Release the switch box handle to turn the mower off and wait for the blade to come to a
complete stop. Unplug the mower.
• While wearing leather padded gloves, wedge a block of wood between the blade and the
mower deck in order to prevent the blade from turning when the nut is being removed.
• Using a 15 mm wrench or socket, loosen the blade nut (1) by turning the nut "COUNTER
CLOCKWISE" to loosen.
• Remove the blade nut (1), the square washer(2), the insulator washer(3), and the blade (4).
• To re-install the blade, position the blade with the cutting edges toward the ground. Assemble
the blade nut, the square washer, and the insulator washer as shown. Using a 15-mm socket
or wrench, turn the blade nut "CLOCKWISE" in order to secure the blade.
NOTE: Be sure to replace the parts in the exact order in which they were removed. When installingthe
cutting blade, verify that it is installed with the curved ends pointing toward the mower deck, and not toward
the ground. Refer to the schematic drawing on page 26 of this Manual.
Fig. 9
22
4
3
2
1
Fig. 10