Accessories And Options - Multimetrix CM 660 Manual De Instrucciones

8. TO REPLACE THE BATTERIES
Please read the safety recommendations before use.
There must be no voltage in the circuit.
The 2 1.5V LR6 (AA) batteries must be replaced when the
is displayed (26):
1. Disconnect the contact points.
2. Set the switch to OFF.
3. Remove the 2 fixing screws and the battery compartment
cover. Replace both the 1.5V LR6 (AA) batteries, paying
careful attention to the polarities (Fig. 3).
4. Follow the reverse procedure to re-assemble (battery
compartment cover and screws).

9. ACCESSORIES AND OPTIONS

Adapter and K sensor temperature probe Ref: ACC N°80
4mm diameter contact points Ref:
2mm diameter contact points Ref:
Removable lighting for the contact points Ref:
28
icon
ACC N°3
ACC N°2
ACC N°1