Audio mode
The radio will automatically switch between Stereo and Mono, depending
on the quality of the signal being received but you can override this function
and manually switch between 'Stereo' and 'Mono'.
Note: You may wish to select 'Stereo' if you are listening to your Micro
System using headphones.
1. Press and hold the Menu button on the Micro System or on the remote
control. Use the rotary control on the Micro System or the Previous/
Next buttons on the remote control to move to Audio setting. Press
the rotary control on the Micro System to 'Select' or the 'Select' button
on the remote control. There are now two different options of 'Forced
mono' and 'Stereo allowed' and the current setting will have a tick next
to it.
2. Use the rotary control on the Micro System or the Previous/Next
buttons on the remote control to move to and choose from the two
options available. Press the rotary control on the Micro System to
Select or the Select button on the remote control to confirm.
3. Press and release the Menu button on the Micro System or on the
remote control to exit from the Menu.
Storing an FM station preset
Your Micro System can store up to 30 FM radio stations in its preset
memories for instant access to your favourite stations.
1.
Tune the Micro System to the FM radio station that you wish to preset.
2. Press and hold the Preset button on the Micro System or the Prog.
button on the remote control for approximately 2 seconds until 'Save to
Preset' is displayed.
3. Use the rotary control on the Micro System or the Previous/Next
buttons on the remote control to move to the preset location that you
would like to store the radio station to (1-30).
4. Press the rotary control on the Micro System to Select or the Select
button on the remote control. The display will confirm 'Preset X saved',
where 'X' is the number of the preset (1-30).
Note: If there is already an existing FM station stored under a preset, it
will be over written when you store the new station.
EN
41