Dab Mode - auna MC-30 DAB Manual De Instrucciones

EN
34

DAB MODE

DAB radio mode
Check that your Micro System is in DAB radio mode. If you are not already
in DAB mode, briefly press and release the Mode button on the front of the
Micro System or on the remote control, until you are in DAB mode (check
the display).
The first time you use the Radio or if the station list is empty, your Micro
System will automatically begin to scan for DAB radio stations. A progress
bar will show the progress of the scan and the number of stations found
during the scan will also be displayed. When the scan is complete your
Micro System will select the first available station and begin to play.
Stations are listed in numerical and then alphabetical order by default.
Wire radio aerial
Please make sure that the wire aerial on the back of the Micro System is
fully extended and adjusted before you attempt to tune to a DAB radio
station (a vertical position is recommended). This will ensure that the
maximum signal strength is available when the Micro System begins to
scan. Extending the aerial also ensures the best possible sound quality.
Changing DAB stations
In DAB mode:
1. Press and release the Tune+ or Tune- on the front of the Micro System
or the Previous/Next buttons on the remote control to open the station
list and move through the available stations.
2. When the station that you would like to listen to is displayed press the
rotary control on the Micro System to Select or press Select on the
remote control. There will be a short delay whilst your Micro System
tunes to your selected station.