Getting Started - auna MC-30 DAB Manual De Instrucciones

GETTING STARTED

CAUTION
Risk of injury! This is a CLASS-1 laser product. Use of controls
or adjustments other than those specifi ed herein, may result
in hazardous laser light beam exposure. Do NOT open the
cover and do NOT attempt to repair it yourself. Refer
servicing to qualifi ed personnel. This product does not
contain any user serviceable parts. Unauthorised handling of
the device may damage it and will void your warranty.
Power connection
1. Connect the speakers to the Left and Right speaker sockets on the back
of the Micro System. Please note that the speakers are shaped and so
you will need to view them from the front before you connect them to
the speaker sockets.
2. Fully extend the wire radio aerial on the back of the Micro System to
receive the best possible radio reception and sound quality.
3. Open the CD compartment (push and release the lid on the front right),
and remove the cardboard shipping protector. Close the CD lid.
4. Plug the mains power plug into the mains power wall socket and switch
on. Welcome to Digital Radio will be displayed and then your Micro
System will go to Standby mode.
5. Pull out the safety strip on the remote control to activate the battery.
Initial set-up
Press and release the Power button on the front of your Micro System
System. The fi rst time you switch on your Micro System or if the station list
is empty, your Micro System will automatically begin to scan for DAB radio
stations. A progress bar will show the progress of the scan and the number
of stations found during the scan will also be displayed.
When the scan is complete your Micro System will select the fi rst available
station and begin to play. Stations are listed in numerical and then
alphabetical order by default.
EN
31