Adjusting The Drive Cable - Briggs & Stratton MURRAY MD2250 Manual De Instrucciones

Cortacésped
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance (Continued)

Adjusting the Drive Cable

(Self-Propelled Units Only)
WARNING: Before you adjust the drive cable,
release the engine stop lever and wait for the
engine to stop.
If the drive system does not engage and disengage correctly,
check the handle for correct assembly. Make sure that all
parts are in good condition, not broken or bent, and that all
fasteners are tight.
Worn parts and cable stretch will change the performance of
the drive system. When you mow in high or thick grass or
on hills, the drive system can slip. If the drive system is
slipping, adjust as follows or take the mower to an
authorized service center.
IMPORTANT: Before you start the engine, operate the engine
stop lever several times. Make sure the engine stop cable
moves freely.
Figure 26: Adjusting the drive cable
14
Note: The engine design does not include a throttle control
or an engine speed adjustment. The engine is set at the best
speed for cutting grass, bagging grass, and for extended
engine life.
1. If the drive system is slipping, turn the cable adjuster
(A, Figure 26) one turn in the direction shown. Test the
drive system and check for slippage.
2. If the drive system still slips, turn the cable adjuster one
more turn to shorten the cable. Again, test the drive
system.
3. Repeat the adjustment and test until the drive system
does not slip.
4. Before you begin to mow, make sure the drive system
will correctly disengage and that the mower will stop. If
the drive system will not disengage, take the mower to
an authorized service center before you operate the
mower.
A
www.murray.com

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido