Handle Height - Briggs & Stratton MURRAY MD2250 Manual De Instrucciones

Preparation (Continued)
Handle Height (Models MD2250 & NMD2250)
1. Remove the wingnuts (A, Figure 4) and bolts (B) from
the right and left handle brackets (C).
2. To raise the handle, mount the lower handle (A, Figure
5) in the high position (B).
3. To lower the handle, mount the lower handle in the low
position (C).
4. Attach the lower handle to the handle brackets with the
bolts and wingnuts removed in Step 1.
Handle Height (Models M2255, NM2255, MP2265,
NMP2265)
1. Remove the wingnuts (A, Figure 4) and bolts (B) from
the right and left handle brackets (C).
2. Mount the lower handle (A, Figure 5a) in the low
hole (C).
Note: Do not mount the lower handle in the high hole (B) .
3. Attach the lower handle to the handle brackets with the
bolts and wingnuts removed in Step 1.
Handle Height (Hi-Wheel Models)
1. Remove the wingnuts (A, Figure 6) and bolts (B) from
the right and left handle brackets (C).
Note: Do not remove the lower set of bolts and nuts securing
the lower handle.
2. To raise the handle, mount the lower handle (D, Figure
6) to a higher adjustment hole (E).
3. To lower the handle, mount the lower handle to a lower
adjustment hole.
4. Replace the bolts and wingnuts removed in Step 1,
tightening securely.
A
Figure 4: Removing the handle adjustment hardware
A
Figure 5: Handle positions (Models MD2250 & NMD2250)
Figure 5a: Handle positions (Models M2255, NM2255,
MP2265, NMP2265)
B
C
B
Figure 6: Handle positions (Hi-Wheel models)
C
C
B
B
C
A
E
A
D
5