Starting The Engine; Important; Rules For Safe And Effective Operation - Briggs & Stratton MURRAY MD2250 Manual De Instrucciones

Operation (Continued)

Starting the Engine

WARNING: The blade will rotate
when the engine runs.
IMPORTANT: Before you start the engine, operate the engine
stop lever several times. Make sure the engine stop cable
moves freely.
Note: The engine design does not include a throttle control
or an engine speed adjustment. The engine is set at the best
speed for cutting grass, bagging grass, and for extended
engine life.
1. Check the oil.
2. Fill the fuel tank with regular unleaded gasoline. Make
sure the gasoline is clean. Leaded gasoline will increase
deposits and shorten the life of the valves.
Note: Do not use gasohol or methanol. Do not use premium
unleaded gasoline.
WARNING: Always use a safety gasoline
container. Do not smoke when adding gasoline
to the fuel tank. When inside an enclosure, do
not add gasoline. Before you add gasoline, stop
the engine and let the engine cool for several
minutes.
3. Make sure the spark plug wire is connected to the spark
plug.
4. Self-Propelled Models Only - Make sure the drive lever
is in the disengaged position (B, Figure 17).
WARNING: To prevent an accident, make sure
the drive lever is in the DISENGAGED position.
When the drive lever is in the ENGAGED
position, do not start the engine.
5. The primer button (A, Figure 18) is on the side of the
engine. Push the primer button. Every time you push the
primer button, wait two seconds. For the number of
times required to push the primer button, see the engine
manufacturer's instructions.
Note: Do not use the primer button to start a warm engine.
Note: Models equipped with Ready Start
feature a primer button. See the engine manufacturer's
instructions for further information.
Figure 18: The engine primer button
6. Stand behind the mower. Use one hand to hold the
7. Make sure the recoil-start rope is not obstructed or
8. If the engine does not start in 5 or 6 tries, see the
Figure 19: Starting the engine

Rules for Safe and Effective Operation

Refer to the 'Operator Safety' section of this manual for
TM engines do not
important rules concerning safe and effective mower
operation.
A
engine stop lever in the operating position (A, Figure
19). Use the other hand to hold the recoil-start grip (B).
caught between the upper and lower handles. Rapidly
pull the recoil-start grip. Slowly return the recoil-start
grip.
"Problem and Repair" Instructions.
A
B
11