Nice O-Box Instrucciones Y Advertencias Para El Uso página 16

– after confirming the selection, clicking on the icon "Work on this system", the
software displays the initial window specifying the system on which the user is
working (fig. 12);
– then connect the relative receiver to O-Box and activate the section
"Receivers" to perform programming as required (refer to chapter 3.4);
- in the same window, click on the icon "System" and in the drop-down (*)
menu, select "Add to system".
(*) Note – the menu associated with the icon "System" is dynamic as it displays
different items according to the relative circumstances. In general the items dis-
played are:
• first line: this states the name of the active system in italics, i.e. the system on
which the receiver being programmed can be saved.
• last line: this states the command "Add to system" to save the (new) receiver
programmed.
• other lines: these state the name of any receivers already present on the sys-
tem. To modify one of these, select the name and modify the parameters as
required. To save the modifications applied, click on the icon "System" and in
14 – English
the drop-down menu, select "Save changes..." (this item is only present if the
active system already has receivers present).
12