Nice O-Box Instrucciones Y Advertencias Para El Uso página 6

[C] – Connector for "BM" memory boards
This connector enables connection of Nice BM memory boards to O-Box. To
connect a board, insert it directly in the connector and proceed with work using
the software (see chapter 3 paragraph 3.3).
[D] – "SM" type connector
The connector enables connection only of Nice receivers in the series "SM" and
"NiceOne" to O-Box. Some of these receivers can be inserted directly into the
connector, while others require cable mod. CABLA06. After connection, the
user can proceed with work using the software (see chapter 3 paragraph 3.3).
Note – The receivers in the series "NiceOne" (OXIT and OX2T) are also
designed to communicate with the software via radio. However, in this case
data transmission is slower than that via the SM connector.
[E] – Connector for external power supply, mod. ALA1
This connector enables connection of O-Box to the electrical mains by means
of an external 12 V dc power supply unit (optional accessory).
Note – Even if O-Box is turned off, the internal battery recharges each time the
power cable is connected to the mains.
[F] – Connector for "USB" cable
This connector enables connection of O-Box to the USB port of a computer by
means of a USB cable. After connection the software can be started up imme-
diately for the relative work session.
Note– Even if O-Box is turned off, the internal battery recharges each time the
USB cable is connected to a powered computer.
[G] – "RS232" serial connector (cable mod. CABLA01)
This connector enables connection of O-Box to the RS232 serial port of a com-
puter by means of a RS232 serial cable (optional accessory). After connection
the software can be started up immediately for the relative work session.
[H] – "TTBUS" connector (cable mod. CABLA05)
This connector enables the connection of Nice tubular motors for sun awnings
and shutters, equipped with TTBUS port to O-Box using the relative cable
(optional accessory).
[I] – Connector for transmitter cloning (cable mod. CABLA03 -
CABLA02 - CABLA04)
This connector enables the connection of Nice transmitters in the series "Bio",
4 – English
"FloR", "Ergo", "Plano" and "Very" to O-Box using the relative cable (optional
accessory). To make the connection open the transmitter to insert the connec-
tion cable (*) and connect the other end of the connector to O-Box (I in fig. 2).
(*) Note:
– for transmitters in the series "Ergo" and "Plano" use cable mod. CABLA04
– for transmitters in the series "Bio" and "FloR" use cable mod. CABLA02
– for transmitters in the series "Very" use cable mod. CABLA03
[L] – Transponder card proximity reader
This proximity reader enables reading (blue cards and grey cards) or writing
(grey cards) of codes stored on the Nice transponder cards. To make the con-
nection, place the card in front of the reader.
[M] – Optical reader connector for transmitters in the series "Bio"
This reader enables reading of the radio code of transmitters in the series "Bio".
To make the connection, insert the optical reader (optional accessory, mod.
CABLA02) in the relative connector (M in fig. 2) and move the transmitter led
near to the head of the optical reader.