Technical Data - EINHELL H126 Manual De Instrucciones

Anleitung H 126 02.11.2001 8:54 Uhr
GB
1) General information
The powerful transmitter type H 126 can be used for
the following Einhell door and gate openers and
controllers:
Garage door openers:
TAF 221
TAF 281
TAF 301
TAF 491L
TAF 311
TAF 321
TAF 351
TAF 2000
TAF 451
GT 52
GT 50/2
Yard gate openers:
FLA 1401
FLA 2401
FLA 2501
STA 401
SIA 601
Controllers:
FSG 116 and FSG 416

2) Technical data

Voltage: 9V monobloc battery (not supplied)
Non-load current:
Transmission frequency:
Coding options:
Operating temperature:
Case:
Case dimensions:
6
Seite 6
3) Starting
Slide the battery cover sideways to open.
Set the transmission code (59049 coding options).
N.B.:
Make sure that the coding switches are always in
the required latching position „+/0" or „-".
Connect up a 9V monobloc battery and insert it
in the battery compartment.
Slide the battery cover back in place.
The H 126 is now ready for use.
The red LED will keep shining until you press
button No. 1.
4) Using the 1-channel hand transmitter
with a garage door or yard gate
opener
a) If you have an Einhell door or gate opener with
automatic transmission code learning mode (e.g.
TAF 311, TAF 321, TAF 351, TAF 2000, TAF
451, GT 52, GT 50/2, STA 401 and SIA 601),
see the operating instructions supplied with the
particular opener for details of how the
transmission code is programmed.
b) If you have one of the following Einhell openers
or controllers - TAF 221, TAF 281, TAF 301, TAF
491L, FSG 116 and FSG 416 - the reception
code has to entered manually at the receiver.
N.B.:
Any number of hand transmitters can be used
with one receiver.
0 mA
27 MHz range
59049
-10°C to +40°C
Black plastic
110 x 25