Replacing The Blade; Removing The Blade - Bosch GKT18V-20GC Instrucciones De Funcionamiento Y Seguridad

2610055543.qxp_GKT18V-20GC 5/26/20 4:36 PM Page 13
Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
Inserting and Releasing
Battery Pack
in the battery/charger list, included with
your tool. Using other types of batteries
may result in personal injury or property
damage.
Slide charged battery pack 13 into the
housing until the battery pack locks into
position (Fig. 3).
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
To remove the battery pack 13, press the
battery pack release button 14 and slide
the battery pack forward.
Press the battery pack release button 14
again and slide the battery pack completely
out of tool housing (Fig. 3).
Fig. 3
14
Saw Assembly
Use only Bosch
batteries recommended
13
26
3

Replacing The Blade

or greater. Do not use abrasive wheels.
Using blade not designed for the saw may
result in serious personal injury and
property damage.
Hex wrench 5 is stored on the tool (Fig. 1).

REMOVING THE BLADE

A. Press the depth stop slider 22 and move
it all the way down (Fig. 1). For changing
the blade, it is best to place the saw on
the side of the motor housing (Fig. 3).
B. Pivot lever
C. Push lock-off button
and press the saw toward footplate
until it audibly engages in the position
for changing the saw blade (the blade
stud 25 or the blade shaft 27 is
accessible through the window in the
blade guard 15).
15a 15
29a
27
2
13
Use only 5-1/2" blade
rated 5500/min (RPM)
3
toward the back (Fig. 3).
2
toward the front
5
25
30
a
28
7
b
29