2610055543.qxp_GKT18V-20GC 5/26/20 4:37 PM Page 17
SECURING TRACKS
damage, only use the track clamps to
secure the track.
Once the track has been placed in the
desired position, insert a track clamp
from each end of the track, then tighten
the clamps against the workpiece (Fig. 7).
PROTECTIVE END CAPS
These caps help to protect the ends of the
tracks from damage, such as when
dropped on their ends. The left
45
caps are NOT interchangeable. If
one or both of the end caps become
damaged, they should simply be replaced
(Fig. 8).
CONNECTING MULTIPLE TRACKS
A.
Pull out the end caps
facing ends of the tracks
connected. Store the end caps in a safe
place (Fig. 8).
B.
Insert the connector
tracks
40
another track onto the other end of the
connector (Fig. 9).
C.
Make sure that the tracks have no gap in
between them. Move the connector
so that the center mark "⇐|⇒" is
positioned at the joint line. Turn all four
locks with a screw driver or a coin to
secure the connection (Fig. 10).
Track Assembly
To avoid the risk of
injury and/or property
50
44
44 and 45
from
40
to be
41
into one of the
as shown and then slide
in
Fig. 8
41
17
50
44
45
40
41
40