Connecting Speaker Cables; Bi-Wire Connection - Yamaha R-S201 Manual De Instrucciones

Ocultar thumbs Ver también para R-S201:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECTIONS
■ REC jacks
• The REC jacks output audio signals of the currently
selected input (except when LINE 3 is selected).
• Volume level, tone control and balance settings do not
affect the REC jacks.

■ Connecting speaker cables

Note
When inserting speaker cables into the speaker terminals, insert
only the bare speaker wire. If insulated cable is inserted, the
connection may be poor and sound may not be heard.
CAUTION
Speaker impedance must be set as shown below.
Speaker connection
SPEAKERS A or
SPEAKERS B
SPEAKERS A and
SPEAKERS B
Bi-wiring
10
En
Remove approximately
10 mm (3/8 in) of
insulation from the end of
each speaker cable.
Speaker impedance
8 Ω or higher
16 Ω or higher
(except for North
America model)
8 Ω or higher

■ Bi-wire connection

Bi-wire connection separates the woofer from the
combined midrange and tweeter section.
A bi-wire compatible speaker has four binding post
terminals. These two sets of terminals allow the speaker to
be split into two independent sections. With these
connections, the mid and high frequency drivers are
connected to one set of terminals and the low frequency
driver to another set of terminals.
Rear panel
Connect the other speaker to the other set of terminals in
the same way.
Note
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
y
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B so that both SP A and B light up on the front panel
display.
Speaker
SPEAKERS A/B

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido