Toto TBV01406 Manual De Instalación Y Del Propietario página 5

II. Installation: Valve
1. Remove protective cover from
valve body.
2. Make sure O-Rings do not fall off.
3. Verify "UP" label is facing/reads
correctly. Use hex wrench
(4mm-included) to fasten the
valve with provided screws.
WARNING:
●Be careful when removing
protective cover. Make sure
no O-rings or screws get lost.
●Make sure valve is facing the
correct direction during
installation.
III. Installation : Trim
1. Position and insert lining plate according to the "UP" label on product.
2. Use a screwdriver to manually fasten the screws on the lining plate.
WARNING:
●Before installing lining plate,
perform a pressure test and verify
that both (HOT and COLD) water
valves are completely open.
●Pay attention to the direction of the
lining plate when installing.
The water discharge port is located
at the BOTTOM of the plate.
●DO NOT apply sealant to lining
plate as this may block water
discharge port. Lining plate
includes a foam sealing strip.
●When fastening the screws on the
lining plate, make sure to compress
firmly. There should be no gap
between the lining plate and the
wall surface.
●DO NOT use an electric wrench to
fasten screws, these should be
tightened manually.
INSTALLATION PROCEDURE
O-ring
Screw
Hex wrench
(4mm)
Lining plate
Screw
5
5
Protective cover
Valve body
After installation
Water discharge port