Display Type - Lutron QS DMX Serie Instrucciones De Instalación Y Operación

Programming (continued)
To unassign DMX channels from a GRAFIK Eye
1. Enter programming mode on the QSE-CI-DMX: Press and hold
2. The LEDs of the zones assigned to
Zone 4
DMX channels will be flashing full on.
Channels 1,2,3
on DMX AABB-CCDD
lower button. Press OK to confirm
Unassign? operation.
3. Exit programming mode: Press and hold the programming
button on the QSE-CI-DMX for 3 seconds. The yellow status
Display Type Setup
which displays intensity as a numeric value. For RGB DMX
step through each entry in the RGB/CMY table. This option is
available only after DMX channel assignment.
1. Enter programming mode on the GRAFIK Eye
"Zone Setup" from the Main Menu. Select "Display type". The
LEDs of the zones assigned to DMX channels will be flashing full
on.

Display type

toggle between display types for each
Set zones
zone. Press "OK" to confirm. Repeat
for all desired zones.
3. Exit programming mode.
Trim Setup
High and low end trim settings limit the maximum and minimum
output of a dimming zone. Follow the instructions below to
1. Enter programming mode on the GRAFIK Eye
"Zone Setup" from the Main Menu. Select "High end" or "Low
end". The LEDs of the zones assigned to DMX channels will
show the high end or low end intensity.
High end
set the desired trim levels. Repeat for
Set zones
all desired zones and trims. Press OK
to confirm.
3. Exit programming mode.
Note: The "High end" and "Low end" trim can only be set if the
zone is assigned to at least one DMX channel.
QS: To enable/disable Master Raise/Lower from affecting
®
RGB/CMY zones (disabled by default)
1. After assigning RGB/CMY zones to the GRAFIK Eye
programming mode on the GRAFIK Eye
Setup" from the Main Menu.
Select "RGB/CMY config".
RGB/CMY Config
Color Programming Tool
The QSE-CI-DMX comes with a standard table of colors already
1. Install the program from the enclosed CD.
values in either RGB (red-green-blue) or CMY (cyan-magenta-
yellow) format. Values can be entered in either decimal or
®
values automatically when you define the boundary values.
table.
7 5 1
®
Master R/L
confirm.
3. Exit programming mode.
Enable
8 6 1
under the bottom hinged door of
9-16 your GRAFIK Eye
1-8
OK
either download your color table
a color table from a QSE-CI-DMX to
your PC for further editing.
®
QS and choose "Zone
®
QS.
®
5