Bosch GSR12V-300FC Instrucciones De Funcionamiento Y Seguridad página 13

▼ 4X BIT TIP HOLDER
bit tip holder. Longer bits could interfere
with proper tool operation and result in user
injury.
The four piece bit tip holder 18 can be used
for convenient on tool storage of your most
commonly used bits.
can be used on its own, or in conjunction
with the belt clip accessory 17. If mounting
both the belt clip and bit holder accessory,
be sure to place the belt clip accessory be-
tween the bit tip holder accessory and the
tool. Always make sure you securely tighten
the mounting screw before use. (Fig. 11).
▶ Protection Against
Deep Discharging
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is dis-
charged, the tool is switched off by means of
a protective circuit.
▶ Variable Speed Controlled Trigger
Switch
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON"
or "OFF" by squeezing or releasing the trig-
ger. The speed can be adjusted from the
minimum to maximum nameplate RPM by
the pressure you apply to the trigger. Ap-
ply more pressure to increase the speed and
release pressure to decrease speed (Fig. 1).
▶ Brake
When the trigger switch is released it acti-
vates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
▶ Forward/Reversing Lever
and Trigger Lock
2610051918.indd 13
Assembly
Only store short screw-
driver bits in the on-tool
The bit tip holder
Operating Instructions
After tool use, lock trig-
ger in "OFF" position to
17
Fig. 12
6
help prevent accidental starts and acciden-
tal discharge.
Your tool is equipped with a forward/revers-
ing lever and trigger lock 6 located above
the trigger (Fig. 12). This lever was designed
for changing rotation of the bit, and for lock-
ing the trigger in an "OFF" position.
Fig. 11
18
6
13
6/11/19 2:10 PM