MSA TransAire 10008292 Manual De Instrucciones página 14

Maintaining the Escape Hood
Reassembling the Escape Hood:
1. Check to be sure there is an O-ring in the regulator
inlet. Thread the pressure regulator on to the cylinder
valve and tighten with a suitable wrench.
2. Place a full air cylinder in the carrier and tie the open-
ing closed around the cylinder neck.
3. Check to be sure there is an O-ring on the hood hose
nipple.
4. Thread the hose nut on the hood inlet and hand-
tighten only.
5. Install the hood hose and hood in the pocket. Close
the hook-and-loop strip.
6. Place the apparatus in its storage location, ready for
use.
14
Component Inspection (At Least Monthly)
1. Check the cylinder. It must be full (gauge reads 2216
or 3000 psi).
2. Remove the hood and hose. Check for holes, cuts, or
other damage.
3. Crack the cylinder valve for a few seconds to make
sure air flows to the hood. Close the valve tightly.
4. Fold the hood and place it and the hose into the
pocket. Close the hook-and-loop strip on the pocket.
TransAire 5-Minute Escape Hood
Replacement Parts List
Part No. Description
484351 TransAire 5-Minute Escape Hood
10008298 Cylinder with valve assembly
10008294 Nylon carrier assembly 5-minute
10012530 Plastic case (for carrying or wall-mounting)
Standard Parts
10008297 Pressure regulator (less hose)
485654 Hood hose
485653 Hood inlet assembly kit
484350 Hood (less inlet assembly)
474929 Wide shoulder strap (optional)
633549 O-ring (cylinder valve)
66835 O-ring (hood inlet)
484056 Teflon hood Std.
10008302 Large hood
TransAire 10-Minute Escape Hood
Replacement Parts List
484351 TransAire 10-Minute Escape Hood
10008299 Cylinder with valve assembly
10008295 Nylon carrier
10012530 Carrying case
TAL 0110 (L) Rev. 2 - 10008901