Installation Of The Appliance In A Line; Connection To The Mains (Service Technician) - Bartscher IR091M01 Manual De Instalación, Uso Y Mantenimiento

8.3.

Installation of the appliance in a line

To fix the appliance in a line (neighboring) follow
the steps:
1. Dismantle the control panel, and remove the
cast iron frame from the chimney if necessary.
2. Apply the sealing tape (A) onto the joining
sides.
B
8.4.

Connection to the mains (service technician)

The device may be connected to the power supply
only by the authorized and qualified personnel,
when the valid regulations are followed and when
appropriate material is used in accordance to the
regulations.
Depending on the model the devices are designed
for connection to the following networks:
230 V 3~ / 380-415 V 3N~
During the installation follow the data on the rating
plate.
Version without the oven
Remove the cover from the terminal strip (A).
Connect the switch-off to the terminal strip (B)
of the device, as shown in the drawing and
block diagram (see the attachment). Use the
H07RN-F cable or better.
3. Place the appliances next to each other and in
a horizontal position (by adjusting the feet).
4. Connect the appliances with the joining
elements.
C
A
For direct connection to the network
install the device assuring disconnection
from the network, having spacing of contact
large enough for disconnection in
conditions of overvoltage category III, which
conforms to the installation principles.
To correctly connect the device, follow the
guidelines below.
A
13
ENGLISH
A
C
GB