Ikegami ISD-A33 Manual De Instrucciones página 27

(1) Image Sensor:
(2) Pixel Number:
(3) Scanning system:
(4) Sync system:
(5) Video output:
(6) Resolution:
(7) S/N ratio:
(8) Minimum object illumination: 0.3Lx/F1.4 (in Hyper AGC mode)
(9) Wide Dynamic Range:
(10) AGC:
(11) Electronic Sensitivity
Control:
(12) White Balance Control:
(13) Private Mask Setting:
(14) Digital Noise Reduction:
(15) Optimum Monitor
Output Selection:
(16) Camera ID:
(17) Local Setup:
1/3-inch Pixim DPS CMOS sensor
Approx. 410,000 pixels, 758 (H) x 540 (V)
525 TV lines / 59.94Hz (60 Hz with Line-
Lock ON), 2 : 1 interlace
INT/LINE-LOCK (phase adjustable) (Line-
lock not usable where the power frequency
and the camera's vertical frequency are
different from each other or when the camera
is DC-driven)
VBS 1.0Vp-p/75 ohms
MON.OUT 1.0Vp-p/75 ohms
Horizontal; 520 TV lines In the high-resolution mode
(690TVL-Effective)
Over 50 dB/rms (AGC OFF, Detail OFF)
Built-in and Variable
ON (AGC, HYPER-AGC)/OFF (LOW, MID,
HIGH) Selectable
Built-in, On (AUTO) or Off Selectable
Maximum 32 times
ATW/ATWex/AWC/MANU, Selectable
Built-in. Up to 8 areas
Built-in, On or OFF, Selectable
Built-in, CRT or LCD types, Selectable
1 Line, up to 24 characters
(alphanumeric and symbols)
By using the switch inside the camera, it is
possible to select and set items according to
the OSD.
Camera ID, AGC ON/OFF, ATW/AWC/
MANU selection and adjustment, Sync LL/
INT switching, and phase adjustment, Wide
Dynamic Range level, Iris Level, Back light
compensation On or Off and BLC Spot area
setting, Electronic Sensitivity Up ON/OFF,
E-22