Night Lights - Key Automation 14A Instrucciones Y Advertencias

EN
SLOW DOWN
7
CLOSING SPEED
8
STEP BY STEP
MOTOR 2
9
DELAY
SLOW DOWN
10
LENGTH
11
ENERGY SAVING

4.8 - NIGHT LIGHTS

The night lights function automatically with the Eclipse flashing light
connected appropriately.
PARAMETERS
1
AUTOMATIC LIGHT
2
LIGHT INTENSIVITY
EXTERNAL LIGHT
3
LEVEL
The Night Light System switches the lights on or of 15 minutes
after the set threshold is exceeded. This delay is to prevent false
26
Motor speed during closing deceleration phase.
1 = minimum
2 = low
3 = medium
4 = high
5 = maximum
SS configuration:
0 = Normal (OP-ST-CL-ST-OP-ST...)
1 = Alternate STOP (OP-ST-CL-OP-ST-CL...)
2 = Alternate (OP-CL-OP-CL...)
3 = Apartment block – timer (always opens)
4 = Apartment block with immediate reclosure (always
opens. Closes if gate is open)
Leaf 2 opening delay with gate closed
0 - 60 sec.
Deceleration distance
0 = Programming decelerations
1 to 100 = Motor deceleration percentage during
opening and closure
Energy saving: enables photocell switch-off when gate
is closed
0= disabled
1= enabled
DESCRIPTION
0 = Night Light System deactivated
1 = Night Light System active (automatically activated
during learning of the stroke with the ECLIPSE flashing
light connected)
1 to 5 = Brightness at which LEDs switch on during the
night
1 = Light sensor tripped with low outdoor light
2 = Light sensor tripped with medium outdoor light
3 = Light sensor tripped with bright outdoor light
1
0
2
0
0
To customise, proceed as follows:
NIGHT LIGHTS
14A
DEFAULT
0
3
2
switch-on or switch-off due to external light sources such as car
headlights.
1 5
0 4
0 60
% (step
0 100
of 1)
0 1
MIN. MAX. UNIT
0 1
1 5
1 3
s