Details; Customising The System - Advanced Settings - Key Automation 14A Instrucciones Y Advertencias

Central modular para uno o dos motores de 24 vcc
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
EN
6 - FURTHER DETAILS

6.1 - Customising the system - ADVANCED SETTINGS

If necessary, users may select the ADVANCED SETTINGS, which
allow modification of the control unit's advanced parameters.
Proceed as follows:
ADVANCED
14A
SETTINGS
PARAMETERS
1
PHOTO 1
2
PHOTO 2
3
PHOTOTEST
4
EDGE TYPE
5
SAFETY EDGE
PEDESTRIAN OPENING
6
LENGHT
AUTOMATIC CLOSING
7
FROM PEDESTRIAN
OPEN
8
FLASH LIGHT
9
PRE-FLASHING
COURTESY LIGHT
10
START
COURTESY LIGHT
11
TIME
LIGHT INTENSIVITY AT
12
END OF MOVEMENT
13
STOP BUTTON
28
DESCRIPTION
Use of PHOTO1 when starting from closed
0 = PHOTO 1 deactivated
1 = PHOTO1 is checked
2 = the gate starts even with PHOTO1 activated
Use of PHOTO2
0 = PHOTO 2 deactivated
1 = enabled during both opening and closing OP/CL
2 =only enabled during opening OP
Photo-device test
0 = off
1 = PHOTO1 on
2 = PHOTO2 on
3 = PHOTO1 and PHOTO2 on
Sensitive edge type
0 = off
1 = 8k2 sensitive edge
2 = NC contact
Sensitive edge tripping mode
0= only tripped during closure with direction reversal
1 = stops the automation (during both opening and closure) and
retreats from the obstacle (travels short distance in opposite
direction)
Pedestrian opening
Time for automatic closure from pedestrian opening (0=off)
1 to 900 Seconds of delay before automatic closure from
pedestrian opening
Flashing light output setup
0 = Fix
1 = Flashing
Pre-flashing time (0 = off)
Courtesy light setup
0 = ON at end of operation for courtesy light time
1 = ON if gate not closed + courtesy light duration time at end of
operation
2 = ON if courtesy light timer has not gone out since start of
operation
Courtesy light duration time (0 = off)
0 = light off after operation
5 = maximum brightness with motor stopped
0 = NC stop button not connected
1 = NC stop button connected
CAUTION: the parameters may vary with respect to those in the
table below, depending on the motor to be installed.
DEFAULT MIN. MAX.
UNIT
2
0
2
1
0
2
0
0
3
2
0
2
0
0
1
% (step
50
30
100
of 1)
0
0
900
s
1
0
1
0
0
20
s
0
0
2
30
0
900
s
2
0
5
1
0
1

Publicidad

Tabla de contenido
loading

Tabla de contenido