Before First Use; Quick-Start Guide; Select Cycle - Hamilton Beach HomeBaker 29881 Manual Del Usuario

Quick-Start Guide

See "Detailed Instructions" section for additional information.
1 Add Ingredients
Place kneading paddle on
shaft, with arrow pointing
up, pushing down as far as
it will go, making sure flat
surfaces are lined up.

Select Cycle

2
Press CYCLE button until desired
program number appears on the digital
display.
3 Start Making Bread
Press START/STOP. The digital display
will show the time remaining in the cycle.
Using oven mitts, turn counterclockwise to unlock the bread pan,
and pull bread pan straight up. Still using oven mitts, shake loaf
from pan and let cool for 10 minutes.
840194103 ENv04.indd 5 840194103 ENv04.indd 5
BEFORE FIRST USE: Wash and dry bread pan and kneading paddle.
NOTE: Do not use metal utensils in bread pan since they may damage the
nonstick surface.
CAUTION! Falling Object Hazard. Breadmaker can wobble and walk during
kneading cycle. Always position it in the center of the counter away from
the edge.
LAST: Yeast. MUST be separate
from wet ingredients
SECOND: Dry ingredients (sugar,
FIRST: Liquid ingredients – room
temperature
Carefully measure and add ingredients to the bread pan in
the EXACT order given in the recipe.
TIP: Premeasure all ingredients, including add-ins (nuts,
raisins), prior to beginning.
Press CRUST and LOAF SIZE buttons to
ADJUST to desired setting (not adjustable
in some cycles).
Add-ins: After the second kneading cycle,
10 beeps will signal you to add fruit, nuts,
etc.
salt, shortening, flour)
To program a Delayed Start, use the
DELAY TIMER + or – buttons to add up
to 12 hours before Cycle will start. Refer
to page 10 for additional information.
Once complete, breadmaker will beep
and begin Keep Warm cycle for up to
1 hour.
Press START/STOP button for 2 seconds
to cancel the Keep Warm cycle and turn
off breadmaker.
Place bread pan in the
breadmaker, turning clockwise
until it locks into place. Close
cover.
NOTE: Bread pan must lock
into place for proper mixing
and kneading.
5
12/15/14 4:18 PM 12/15/14 4:18 PM