Starting The Machine - Bona Belt UX Manual De Funcionamiento Y Mantenimiento

Starting the Machine

To start the machine proceed as follows:
1.
Become familiar with the
machine and read all
instructions & safety notices.
Ensure that all operators
read this manual.
5.
Open the side guard (A).
Only use 750 mm x 203 mm abrasive belts.
2.
If using DCS, connect tha
adaptor supplied with the
machine and DCS hose
directly.
If using a dust bag, place the
dast bag on the suction pipe
by tying the cord.
6.
Lower the tensioning unit
using the drum tensioning
lever (A).
3.
Locate the power supply. The
socket must be compatible
with the plug.
To avoid electrical hazards
the socket must be grounded
with a 20 A fuse.
7.
Insert the abrasive belt
(A), ensuring it protrudes
approximately 2 mm from
the rubber drum area but
runs along the inside of the
tensioning unit.
Bona Belt UX Manual
4.
Wind the cable around the
cable safety arm (A) to keep
it away from the path of the
machine.
8.
Tighten the drum using the
drum tensioning lever (A).
19
EN