The First Wash Cycle; Technical Details; Electric Connections - Indesit IWDE 127 Instrucciones Para El Uso

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washer dryer. If this is not the case, replace the
socket or the plug.
! The washer dryer must not be installed ou-
tdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washer dryer has been installed, the
electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, setting the 90°C pro-
gramme without a pre-wash cycle.

Technical details

Model IWDE 127
59,5 cm wide
Dimensions 81,5 cm high
54,5 cm deep
from 1 to 7 kg for the wash
programme;
Capacity
from 1 to 5 kg for the drying
programme
Please refer to the technical
Electric
data plate fixed to the ma-
connections
chine.
maximum pressure 1 MPa
Water (10 bar) minimum pressure
connections 0.05 MPa (0.5 bar) drum
capacity 52 litres
Spin speed up to 1200 rpm
Wash: programme 2; tem-
perature 60°C;
run with a load of 7 kg.
Control Drying: the smaller load must
programmes be dried by selecting the "Iron"
according to "dryness level. The load
regulation must consist of 2 sheets, 1 pil-
EN 50229 lowcase and 1 hand towel;
the remainder of the load
must be dried by selecting the
"Cupboard"
This appliance is compliant
with the following European
Community Directives:
- 2004/108/CEE (Electroma-
gnetic Compatibility)
- 2006/95/CE (Low Voltage)
- 2012/19/EU - WEEE
GB
dryness level.
17