Access Codes; Rechargeable Battery - ESYLUX PROTECTOR Operación Manual

GB OPERATING INSTRUCTIONS
4 • OPERATION AND PROGRAMMING
3.
Testing and programming outputs
[Akustische Signalgeber] (sounder)
- [Status inaktiv ändern] (status: disabled change) enables you to disable the sounder outputs so that they are not actuated when the main
alarm is triggered.
- [Delay] must be activated in order to use the verification time option. See menu 2.1 Radio alarm groups and 2.2 Wired alarm groups
[Störung] (fault)
- [Status inaktiv ändern] (status: disabled change) enables you to disable the fault relay so that it is not actuated in the event of a fault.
[Relais 1] (relay 1)
- [Status] allows you to reverse the relay operation so that it is constantly energised in idle mode and drops out when activated. This is an
additional safety aspect, as the contact also switches if the control centre's power supply is completely cut off (total failure). This reduces the
battery life in the event of a power failure, as the constantly energised relay consumes energy.
- [Typ] (type) defines when relay 1 should be activated:
Sounder: relay 1 is activated when the sounder outputs are actuated (main alarm)
Fault: relay 1 is activated when the fault relay is activated
Zone 1 - 11: relay 1 is activated when the selected alarm group is in alarm status
[Relais 2] (relay 2)
see relay 1
4. General settings

4.1. Access codes

To change the access codes for the various access levels in the menu
4.2. Date / time
Change the date and time
Navigate with buttons [ ] or [ ] and change the values with buttons [ ] or [ ]
Confirm the settings by pressing [OK]
4.3. Settings and language display
- [LANGUAGE] change the language
- [+] / [-] change the backlighting of the display
- [Piep aktiv] (beep active) activates/disables the key tones
4.4. Ethernet
Configuring the network settings
- [IP] shows the MAC address and allows you manually assign IP addresses (IPv4)
Navigate with buttons [ ] or [ ] and change the values with buttons [ ] or [ ]
Confirm the settings by pressing [OK]
- [DHCP] requires an automatically assigned IP address
Exit the menu with [OK], save your settings in menu 5. Save configuration and switch off the power supply of the control centre.
Switch the power back on, then save the configuration once again in menu 5. Save configuration
- [NET] is for setting the subnet mask
Navigate with buttons [ ] or [ ] and change the values with buttons [ ] or [ ]
Confirm the settings by pressing [OK]
- [GW] is for setting the gateway address (IPv4)
Navigate with buttons [ ] or [ ] and change the values with buttons [ ] or [ ]
Confirm the settings by pressing [OK]
- [DISABLE] is for disabling the network monitoring. Choose this setting if the control centre is not connected to ETHERNET,
otherwise a fault message will be generated.
The data transfer of the network is not monitored.

4.5. Rechargeable battery

Indication of the battery status and remaining battery life in days (max. 3 years)
- [DISABLE] is for disabling the monitoring. Select this setting if the control centre is not connected to a battery, otherwise a fault
message will be generated.
26