Application Notes - Peavey RQ 200 Guia De Funcionamiento

30. Battery Compartment:
Located underneath the RQ 200 is the battery compartment. Removing the compartment door
reveals the two 9V battery positions as well as the optional phantom power battery position. Placing
a third 9V battery in the phantom position (see diagram below) will increase the phantom power
from 8 VDC to 17 VDC. See Phantom Power, #29, for more information. Always use 9V alkaline
batteries.

APPLICATION NOTES

1. Microphones and other low impedance sources should be connected to the XLR mic inputs;
high level line inputs, such as electronic musical instruments, should be connected to the line
inputs. Stereo line level sources (synth, tape, CD, camera audio, etc.) should be connected to
one of the stereo channels, or to two of the mono line inputs (one panned left, the other
panned right).
2. The house power amplifier inputs should be connected to the main Left and Right 1/4"
outputs using TRS to TRS (or TRS to XLR depending on amp inputs) for balanced
applications. If your power amp does not have balanced inputs, any of the Main Outputs
may be used.
3. Connect the monitor power amplifier input to the Monitor Output. If the Effects Output is not
being used, it can serve as a second Monitor Output (post-EQ).
4. If an effects device is used, connect its input to the Effects Output of the RQ
Remember to adjust the Effects Master to insure you are not clipping the input of the effects
device.
5. The effects device outputs are connected to one of the inputs on the RQ
very important to turn the EFX knob to Ò0Ó on this input, channel in order to avoid a feed-
back loop.
6. Three different types of output jacks are provided: 1/4" stereo TRS (bal/unbal), stereo RCA
(unbalanced), and 3.5mm (unbalanced). Though it is possible to use all three outputs
simultaneously, it is not recommended due to the loading effects it may cause. Incidentally,
these outputs offer variety in order to cover most applications where a portable mixer is
needed to record audio to video, DAT, etc. in addition to sound reinforcement.
Ð +
*
Phantom
*Optional for +17V Phantom Power
USE 9V ALKALINE BATTERIES
Ð
Ð +
Mixer
7
+
Mixer
ª 200.
ª 200. NOTE: It is