Special Modes Setting - Gree XK64 Manual De Usuario

Controller For The Air Source Heat Pump Water Heater

6.3 Special Modes Setting

If the heat pump of a water heater equipped with an electrical heater is faulty,
users can press and hold MODE+RAPID for 5 seconds in any mode under the On state
to enter the E-HEATER mode.
Note: The E-HEATER mode can be used only when the heat pump is faulty. In this
case, contact the aftersales service immediately.
The E-HEATER mode is shown in the following figure.
In the E-HEATER mode, users can press the MODE button to switch to the
HOTWATER mode. Note that the E-HEATER mode will be cancelled automatically and
6