Setting The Correct Time - Danfoss TP5001 Serie Instrucciones Del Usuario

The YEAR number will fl ash, use Λ or V to correct
GB
the year.
Use - or + to move to MONTH, then use Λ or V to
correct month.
Use - or + to move to DATE in month, then use Λ or
V to correct day in month.
If you attempt to select an invalid date the unit software will reject it
and apply the nearest valid date. It is recommended that date is set in
the order, yy/mm/dd.

Setting the correct time

After setting the date, press PROG to display the
time. The time display will fl ash on and off .
Use the + and - buttons to set the correct time
(press and hold to change in 10 min. increments).
Setting the correct day
The day of the week is set automatically. Press
PROG to return to normal operation (RUN).
Accepting the preset programmes
If you are happy with the preset times shown in the table on page 2 you
need take no further action.
4