Stopping The Engine; Starting The Engine - Mosa GE 6000 SX Manual De Instrucciones

I
ENGINE STARTING - STOPPING THE ENGINE
GB
F
Check daily
NOTE
!
Do not alter the primary conditions of regulation
and do not touch the sealed parts.

STARTING THE ENGINE

lnsert the electric protection device (D) lever towards
above, see page M37 –
OFF
ON
Introduce the key (Q1), turn it clock-
START
wise completely, leaving it as soon as
the engine starts.
Let the engine run for some minutes before drawing
the load.
GE 6000/6500 SX/GS
GE 6000/6500 DES/GS-L
GE 7000 SX/GA

STOPPING THE ENGINE

 Before stopping the engine it is compulsory to
effect the following operations:
- stop to draw three/single-phase current from the
auxiliary sockets.
Make sure that the unit is not supplying any power.
Disconnect the electrical protection device (D) lever
downward.
OFF
ON
Stop the engine turning the key (Q1) it
START
counter clockwise, OFF position, then
take it out.
 NB.: for safety reason the key must be kept
by qualified personel.
CAUTION
!
If the engine fails to start, do not insist for at least
15 seconds.
Space the further operations waiting for at least
4 minutes.
CAUTION
!
RUNNING-IN
During the first 50 hours of operation, do not use
more than 60% of the maximum output power of
the unit and check the oil level frequently, in any
case please stick to the rules given in the engine
use manual.
M
21
REV.1-09/06