Troy-Bilt TB WC33 XP Manual Del Operador página 13

LCD Service Minder and Hour Meter
(Electric Start Models Only)
When the ignition key is rotated out of the STOP position but not
into the START position, the LCD Service Minder and Hour Meter
will briefly display the battery voltage, followed by the tractor's
accumulated hours.
NOTE: Hours of mower operation are recorded any time the
ignition key is rotated out of the STOP position, regardless of
whether the engine is started.
Change Oil
The LCD will display the letters "CHG", followed by the letters
"OIL", followed by the letters "SOON", then finally followed by the
meter's accumulated time. "CHG/OIL/SOON/TIME" will alternate
on the display for seven minutes after the meter reaches 50
hours. This oil service minder interval will occur every 50 hours
for the following two hours. Before the interval expires, change
the engine oil as instructed on page 18 in the Maintenance
section of this Operator's Manual.
Low Battery
At startup, the battery voltage is briefly
displayed then changes to accumulated
hours. The letters "LO" will display
followed by the letters "BATT" and then followed by the meter's
accumulated time. "LO/BATT/TIME" is displayed on the LCD when
the voltage drops below 11.5V. When this occurs, the battery
is in need of a charge or the engine's charging system is not
generating sufficient amperage. Charge the battery as instructed
on page 29 in the Service section of this manual or have the
charging system checked by your local service dealer.
S
ection
4 — c F
ontrolS and eatureS
13