Operation; Starting The Engine; Stopping The Engine - Troy-Bilt TB WC33 XP Manual Del Operador

Operation

Gas and Oil
The fuel tank has a capacity of two gallons. Remove the fuel cap
by turning it counter-clockwise. Use only clean, fresh (no more
than 30 days old), unleaded gasoline. Fill the tank no higher than
four inches below the top of the filler neck to allow space for fuel
expansion.
WARNING!
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
NOTE: Your lawn mower is shipped with oil in the engine.
However, you MUST check the oil level before operating.
CAUTION:
each use as instructed in the Engine Operator's
Manual. Add oil as necessary. Failure to do so may
result in serious damage to your engine.

Starting the Engine

Electric Start
Refer to page 1114 in the Operation section of this manual for
gasoline and oil fill-up instructions.
1. Release all controls on the mower.
2. Move the gear shift lever into the neutral (N) position.
3. Insert the key into the ignition switch.
4. If starting a cold engine, place the throttle/choke control
all the way forward, into the CHOKE position. If restarting
a warm engine, place the throttle/choke control into the
FAST (rabbit) position.
5. Turn the ignition key clockwise to the START position. After
the engine starts, release the key. It will return to the RUN
position.
CAUTION:
position for longer than five seconds at a time.
Doing so may cause damage to your engine's
electric starter.
6. Move the throttle/choke control into the FAST (rabbit)
position.
NOTE: Never leave the throttle/choke control in the CHOKE
while operating the mower. Doing so will result in a "rich"
fuel mixture and cause the engine to run poorly.
14
Use extreme care when handling
Always check the engine oil level before
Do NOT hold the key in the START
Recoil Start
Refer to the Set-Up and Assembly section of this manual for
gasoline and oil fill-up instructions.
1. Release all controls on the mower.
2. Move the gear shift lever into the neutral (N) position.
3. Insert the key into the ignition switch.
4. Turn the ignition key clockwise to the RUN position.
NOTE: Once started, turning the key to the STOP position
will kill the engine in the same manner as if the unit was
started electronically.
5. Grasp starter rope handle and pull slowly until rope pulls
slightly harder. Let rope rewind slowly. Then pull rope with
a rapid, full arm stroke. Let rope return slowly. If engine fails
to start after three pulls, repeat instructions (try setting
throttle at fast setting).
6. Move the throttle/choke control into the FAST (rabbit)
position.

Stopping the Engine

WARNING!
If you strike a foreign object, stop the
engine and remove the ignition key (if so equipped).
Thoroughly inspect the machine for any damage.
Repair the damage before restarting and operating.
1. If the blades are engaged, release the blade control.
2. Turn the ignition key counter-clockwise to the STOP
position.
3. Remove the key from the ignition switch to prevent
unintended starting for electric start models.
5