Insert Batteries - Revell Control TIGERMEET Manual De Instrucciones

HELICOPTER
Stabilizer
Control LED
Undercarriage
Controller
Starting position
Note: The throttle stick and
trimming dial must be in
the down position when
the controller is turned on.
Antenna
Hook for
carry strap
Throttle trim dial
Throttle stick /
Left/right
rotation (yaw)
Yaw trim dial
ON/OFF
switch
Synchronization button
(should only be used
for repairs / further
details available online)
Mode 2 controller functions (throttle on left side)
1. To open the battery cover, slide
it downwards.
Note: Before charging, wait 10 to 15 minutes for the batteries to cool down to avoid damage. Never leave charging batteries unattended.
1. Turn off the helicopter and the controller. Separate the red connectors on the
helicopter's fl ight cable (pic. 1).
2. Remove the battery holder from the mount (pic. 2).
3. Connect the 230 V mains adapter to the LiPo charger. Insert the mains adapter into
a plug socket. The RED LED on the charger lights up. Connect the LiPo battery to
the charger. The GREEN LED lights up (pic. 3). Do not force.
4. The battery is fully charged after 60 minutes. The GREEN LED goes out. Disconnect
the battery immediately from the charger.
5. Insert the battery in the battery holder and snap it into place in the helicopter
(pic. 4). Make sure that the cables do not come into contact with the landing
gear on landing.
The helicopter can fl y for about 10 minutes after approximately 60 minutes of charging.
The charging process is electronically monitored and stopped automatically after 60 minutes.
RC_Anleitung_Tigermeet_01.indd 7 RC_Anleitung_Tigermeet_01.indd 7
Helicopter and controller p

Insert batteries

2. Insert eight 1.5 V AA batteries according to
the polarity in the battery compartment.
Charging the helicopter battery
pic. 1
HELICOPTER BATTERY:
Handle
LED display
Forward/backward
Accessories:
trim dial
Automatic LiPo charger
Forwards/backwards
fl ight (pitch)
Left/right fl ight (roll)
Roll trim dial
Control reverse
switches
Synchronization key connector
(should only be used for repairs;
further details available online)
3. Slide the battery compartment
cover back up and close.
Coaxial rotor system
Fuselage fi xing pins
Battery compartment on
underside of helicopter
Removable
helicopter battery
Removable battery
holder on underside
of helicopter
Mains adapter for charger
Ball point wrench
4. If the LED emits a continuous green light, the
battery charge is OK. If the LED is red, the
batteries are too weak and must be recharged.
pic. 4
pic. 2 pic. 3
28.04.2009 13:39:40 Uhr 28.04.2009 13:39:40 Uhr
7