Preventative Maintenance; Daily Maintenance; Weekly Maintenance - Matrix IC3 Manual De Usario

PREVENTATIVE MAINTENANCE

Regular maintenance must be performed on the Matrix IC3 Indoor Cycle for optimal
performance and longevity. Please read and follow all instructions below. If the in-
door cycle is not maintained as described, components may wear excessively and
the Matrix IC3 Indoor Cycle may become damaged. Improper maintenance will void
the warranty terms. If you have questions about maintenance, contact your local
distributor or refer to www.indoorcycling.com.
Note: Many maintenance procedures require lubricant spray.
Manufacturer recommends Brunox or any other solvent-free lubricant.

Daily maintenance:

1. Make sure that the Matrix IC3 Indoor Cycle is level. If the Matrix IC3 Indoor Cycle rocks
on your floor, turn the leveling feet underneath the front or rear stabilizer until the rocking
motion is eliminated (see „How to move the Matrix IC3 Indoor Cycle" on page 12).
2. After each user finishes exercising, the Matrix IC3 Indoor Cycle should be disinfected and
cleaned to maintain a hygienic environment. First, apply a disinfectant spray to the handle-
bars and the saddle. Using a lint-free cloth, dry the handlebars and the saddle. Next, apply a
small amount of disinfectant to a lint-free cloth and clean the adjustment knobs and the lock
handles. Avoid using strong detergents on the Matrix IC3 Indoor Cycle frame.

Weekly maintenance:

1. Apply a small amount of the lubrication spray to a lint-free cloth. Thoroughly clean
the frame, the handlebar slider, the seat sliders, the flywheel, and the plastic parts of the
Matrix IC3 Indoor Cycle.
2. For optimal performance of the resistance
2
system, and to minimize wear on the brake pad,
the
acid-, silicone- and solvent-free spray lubricant
should be applied to the brake pad using the lubri-
cation holes on the plastic part of the brake pad. If
fuzz or lint appears on the brake pad, the brake pad
has become too dry. Lubricant spray should be ap-
plied more frequently. Make sure brake pad is tho-
roughly soaked from end to end with lubricant spray.
Wipe off any excess.
|
Version 1.0 2013 IC-MXIC3B-01 Copyright by Indoorcycling Group GmbH 2013 www.indoorcycling.com ENG 13
$