Preparing To Make A Cut; Releasing The Cutting Head - Evolution R185 CMS Li Instrucciones Originales

FINAL ADJUSTMENT CHECKS
With the machine switched OFF and the battery removed carry out
the following (when all adjustments have been made);
• Set the machine at each of the maximum settings.
• Lower the blade to its lowest position and rotate the blade by
hand, (it is advisable to wear gloves whilst doing this), and ensure
that the blade does not foul on any part of the machine castings or
guards.

PREPARING TO MAKE A CUT

WARNING: Do not over-reach.
Keep good footing and balance. Stand to one side so that your face
and body are out of line of a possible kickback.
Freehand cutting is a major cause of accidents and should not
be attempted.
• Ensure that the workpiece is always firmly resting against the
fence, and where practical is clamped with the top hold down
clamp to the table.
• The saw table should be clean and free from any sawdust, etc,
before the workpiece is clamped into position.
• Ensure that the 'cut-off' material is free to move sideways away
from the blade when the cut is completed. Ensure that the 'cut-off'
piece cannot become 'jammed' in any other part of the machine.
• Do not use this saw to cut small pieces. If the workpiece being
cut would cause your hand or fingers to be within 150mm of the
blade, the workpiece is too small.

RELEASING THE CUTTING HEAD

The Cutting Head will automatically rise to the upper position once
it is released from the locked down position.
It will automatically lock in the upper position.
To release the cutting head from the locked down position:
• Gently press down on the cutting handle.
• Pull out the head latching pin (Fig. 15) and allow
the cutting head to rise to its upper position.
If release is difficult:
• Gently rock the cutting head up and down.
• At the same time twist the head latching pin clockwise and pull
outwards.
Note: We recommend that when the machine is not in use the
cutting head is locked in its down position with the latching pin
fully engaged in its socket.
THE MOTOR ON/OFF SWITCH
The ON/OFF motor trigger features an interlock lever to prevent
accidental starts. (Fig.16)
It is positioned inside the cutting handle.
• Slide the interlock lever to the left.
• Press the switch to start the motor.
• Release the switch to turn off the motor.
www.evolutionpowertools.com
Fig. 15
Fig. 16
16