Playcore Swing-N-Slide PB 8233 Instrucciones De Montaje página 16

Assembly Plan
Fig. 9
Hammer
3/8'' hole
T-nut
t-nut
Bottom Beam Clamp
(4) 1-1/4'' screws
Use Screwdriver to aid in tightening
3-1/2'' Swing Hanger
Swing Hanger
Swing Hanger Assembly
1. Tap T-nut into 3/8'' hole as shown in Step 1.
2. Place a bottom beam clamp over the swing hanger as shown in Step 2.
3. Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the
T-nut. A screwdriver may be used to twist the hanger. Orient swing hanger as shown in Step 3.
4. Use (4) 1-1/4'' screws to secure beam clamp as shown in Step 4.
5. Check hanger to ensure it does not spin.
6. Repeat for all swing hangers.
16