Playcore Swing-N-Slide PB 8233 Instrucciones De Montaje página 17

Fig. 10
A-FRAME ATTACHES
HERE
x4
Fig. 10b
Loc Nut
Washer
4-1/4''
Swing Hanger
TWO CHILD SWING
MOUNTS HERE
Fig. 10a
2''
Carriage Bolt
per bracket
(2) [PF 3662] 2'' x 4'' x 20''
Fig. 10c
Two Child Swing Supports:
1. Along top of Swing Beam mark placement for Two Child
Swing 2'' x 4'' Supports as shown in (Fig. 10).
2. Position four beam brackets (right and left) in position
on beam making certain the outside of the braces are
18'' apart and the nailing edge of the bracket is flush
32-1/2''
with the top of the beam (Fig. 10a). Attach using three
2-1/2'' screws per bracket.
3. Attach four swing hangers to the supports using 5/16''
flat washers and loc nuts as shown in (Fig. 10b).
4. Attach using two 2'' Carriage bolts, 5/16" flat washers
and loc nuts per bracket (Fig. 10a).
5. Place Bolt Covers over the top of the swing hangers and
14-1/2''
loc nuts. Secure to the supports using 2-1/2'' screws per
Bolt Cover, as shown in (Fig. 10c).
17
Assembly Plan
Loc Nut
Washer
(3)
2-1/2''
screws
18"
(2) 2-1/2'' screws
Bolt Cover